Dear Gurus, I have a question on the copy model inspection plan from plant to plant in QM Model Tcode QP01.
Should the copy model function can copy exactly the same from the previous plant without reset the MIC Std Value as per origin?
MIC been set as general at each plant level.(Use Incomplete Copy Model) eg
Plant A, MIC-A, value: min 4
Plant B, MIC-B, value: min 4
Actual inspection plan
Plant A, MIC-A, value: 4-8
Plant B (don't have yet)
when I wish to copy inspection plan from Plant A to Plant B, MIC std been copy to Plant B with pH value:4-8. but when I try to change the plant code in the inspection plan from plant A to plant B in the each MIC then hit Enter, then the MIC std been reset to min 4. with message:" Insp. characteristic is overwritten by master insp. characteristic. Message no. QP356"
Result:
Plant B, MIC-B, value: min 4
Besides, I have tried another way which is without change the plant code, it was successfully remain the specific std value.
Result:
Plant B, MIC-B, value: 4-8
> any idea how to copy exactly the same value without reset ?
> Change previous plant code of MIC is necessary right?
Thanks for help !!!!